Fork rating, Warning, Operation – Lull 944E-42 Operation Manual User Manual
Page 72

70
Model 944E
Origin 3/04
Operation
All approved forks for this vehicle are marked with a maximum load capacity rating. 
This rating is stamped on the left edge of the fork (1) just below the fork pivot shaft 
(2). The rating is listed in U.S. pounds and based upon a 24" (610 mm) load center 
(3). This rating specifies the maximum load capacity that the individual fork can 
safely carry at the maximum load center (4) of 24" (610 mm)
Since forks are always used in multiples, the total rating of any combination of forks 
will be the sum of their rated capacity. Other than block forks, all forks should be 
used in matched pairs. Block forks should be used in matched sets.
The maximum load capacity for this vehicle is 9,000 pounds (4.082 Kg). The 
matched pair or set of forks used on this vehicle should have total load ratings which 
equal or exceed 9,000 pounds (4.082 Kg). When the load rating of the vehicle differs 
from the load capacity of the forks, the lower value becomes the overall load 
capacity.
Fork Rating
WARNING:
DO NOT exceed the total rated capacity of the spe-
cific pair of forks being used. Forks can break causing loss of load and 
possible death or serious personal injury to the operator or personnel in 
the area. If the total rated capacity of the forks exceeds the capacity of 
the vehicle, the vehicle capacity should not be exceeded.
XXXX - 24
XXXX - 24
OU0131
1
2
3
4
