BRK electronic SCO2B - Manual (Page 2)

brkelectronics.com
A R C H I T E C T U R A L A N D E N G I N E E R I N G S P E C
I N S T A L L A T I O N O F A L A R M
The combination smoke and carbon monoxide alarm shall be a BRK Model SCO2B and
shall provide at a minimum the following features and functions:
1. An ionization smoke sensing chamber and an electrochemical CO sensor.
2. Powered by a supervised 9V alkaline battery and features a solid state piezo horn
rated at 85dB at 10 ft. and the unit shall be capable of self restoring.
3. The unit shall perform self diagnostic tests and issue a malfunction warning (three
chirps) if the unit malfunctions.
4. The unit shall have an "End of Life" signal. This signal should be capable of
temporarily being silenced for up to 2 days. After about 2 days, the signal will
resume. After about 2-3 weeks the signal cannot be silenced.
5. A visual power-on indicator to confirm unit is receiving power. Separate LED 's to
indicate a smoke or CO alarm.
6. The CO sensor is adjusted not to detect CO levels below 30 PPM and will not
alarm when exposed to constant levels of 30 PPM for 30 days. It will alarm
at the following levels: 400 PPM CO between 4 and 15 minutes, 150 PPM CO
between 10 and 50 minutes and 70 PPM CO between 60 and 240 minutes.
7. Two Latching features: Alarm Latch to easily identify initiating alarm after alarm
condition has subsided. Low battery latch: to visually identify which unit is in low
battery condition. Two Silence Features: Alarm Silence to temporarily silence
nuisance alarms. Low Battery Silence to silence low battery chirp for up to 8 hours.
8. Two Locking features - tamper resistant locking pins that lock battery drawer
and/or alarm to mounting bracket.
9. The unit shall be capable of operating between 40°F (4°C) and 100°F (38°C) and
relative humidity between 10% and 95%.
10. The unit shall contain mounting hardware and shall be listed for wall or ceiling
mounting.
11. The unit shall at a minimum meet the requirements of UL217 and UL2034,
CSFM, NFPA 72 and 720 and the ICC.
S H I P P I N G S P E C S :
T E C H N I C A L S P E C S
Individual Carton Dimensions 5.69"L x 2.25"W x 5.59"H
Weight 0.59 lbs.
Cube 0.041 ft3
UPC 0 29054 00089 7: SCO2B
0 29054 00736 0: SCO2LB
Master Carton Dimensions 14.43"L x 6.19"W x 12.63"H
Master Pack 12
Weight 7.6 lbs.
Cube: 0.65 ft3
I2of5: 200 29054 00089 1: SCO2B
800 29054 00736 6: SCO2LB
Pallet Information
Cases per Layer 19
Number of Layers: 3
Cases per Pallet: 57
Units per pallet: 684
Cube: 42.2 ft3
Weight: 498 lbs.
Alarm Dimensions: 5.6” dia x 2.0”H
Weight: 7.6 oz
Operating Voltage: 9V battery powered
Temperature Range: 40°F (4°C) to 100°F (38°C)
Humidity Range: 10% to 95% relative humidity (RH)
Audio Alarm: 85dB at 10 feet
Test/Silence: Electronically simulates smoke condition or carbon
monoxide condition, causing the unit to alarm
Press and hold test/silence button
Alarm Reset: Automatic when smoke and/or CO clears
Smoke Sensor: Dual chamber ionization
CO Sensor: Electrochemical
Indicator Lights/Sounds:
DC Power:
Intermittent Green LED
Local Alarm: Red LED flashes rapidly
Alarm Latch: Red LED flashes 2 sec on/2 sec off after local alarm stops
Low Battery Latch: Green LED flashes on for 2 seconds, off for 2 seconds.
Note: Latching features are active for 15 minutes only.
Listing: Listed to UL217 and UL2034 Standards
©2010 BRK Brands, Inc. a Jarden Corporation
Company (NYSE: JAH)
3901 Liberty Street Road
Aurora, IL 60504-8122
All rights reserved
First Alert is a registered trademark of the First Alert Trust
BRK is a registered trademark of BRK Brands, Inc.
CM3080
5.6"
TOP VIEW SIDE VIEW
2.0"
CAT.
SCO2B/SCO2LB
MOUNTING
BRACKET
BATTERY DRAWER LOCK
Remove Pin
Push locking pin through
hole near battery drawer
on the back of the alarm.
Installation of this smoke alarm must conform to NFPA 72. Always check your local
building codes. Follow all instructions for placement as outlined in the user’s manual.
THE PARTS OF THIS SMOKE ALARM
BOTTOM OF ALARM
1. Mounting bracket
2. Mounting slots (1 of 2)
3. Locking Pins
4. Battery Drawer Latch
5. Battery Drawer - Install
9V battery here
TOP OF ALARM
1. Test/Silence Button
2. Power Light (Green)/
Smoke Alarm light (Red)
3. CO Alarm Light (Red)
4. Battery Drawer
5. Behind Cover: Alarm 85 dB horn
1
2
3
2
5
4
3