Apple iMac G3 (Original) - Manual (Page 31)

Information you need in the United Kingdom
This terminal equipment is intended for direct connection to the analogue Public
Switched Telecommunications Network and is approved for use within the United
Kingdom with the following features:
m Modem facility
m Autocalling facility
m Autoanswer facility
m DTMF signaling
m Operation in the absence of proceed indication or upon detection of proceed
indication
This product is in conformity with relevant regulatory standards following the
provisions of European Council Directives 73/23/EEC (Low Voltage Directive) and
89/336/EEC amended by 92/31/EEC (EMC Directive).
Information you need in Germany
Diese Modem-Karte ist als Endeinrichtung vorgesehen und muss an ein TAE mit F-
Kodierung angeschlossen werden.
Diese Endeinrichtung ist in Konformität gemäss Niederspannungsrichtlinie 73 / 23 /
EWG sowie EMC-Richtlinien
89 / 336 / EWG und 92 / 31 / EWG.
Information you need in France
Ce matériel est conforme aux normes applicables de sécurité éléctrique d’après la
directive 73 / 23 / CEE et aux normes applicables de comptabilité éléctromagnétique
d’après la directive 89 / 336 / CEE, modifié par la directive 92 / 31 / CEE.
Information you need in Australia
All telecommunications devices are required to be labelled as complying to the
Australian telecommunications standards, ensuring the health and safety of the
operator and the integrity of the Australian telecommunications network. To provide
compliance with the Australian Communications Authority’s technical standards,
please ensure that the following AT commands are maintained:
m ATB0 (ITU/CCITT operation)
m AT&G0 (no guard tone)
m AT&P1 (33/66 pulse dial make/break ratio)
m ATS0 = 0 or ATS0 = 1 (no answer or answer greater than one ring)
m ATS6 = 95 (DTMF period between 70–255 ms)
m ATS11 = 95 (DTMF period between 70–255 ms)
For calls that are automatically generated, a total of three call attempts are allowed to a
telephone number, with a minimum period between calls of 2 seconds. If the call does
not connect after three attempts, 30 minutes must expire before automatic redialing
may be initiated. Failure to set the modem (and any associated communications
software) to the above settings may result in the modem being non-compliant with
Australian telecommunications standards. Under these circumstances a user could be
subject to significant penalties under the Telecommunications Act 1997.
This modem must be properly secured in order for you to use it. Telecommunications
network voltages exist inside the computer and the telecommunications line
connection must be removed before opening the computer.
Information you need in New Zealand
This modem is fully approved to operate on the New Zealand telecommunications
network under Telepermit number PTC 211/98/119. All telecommunications devices
are required to hold a Telepermit and be labelled accordingly with the approved
Telepermit number to comply with the New Zealand telecommunications standards,
ensuring the health and safety of the operator and the integrity of the New Zealand
telecommunications network.
Customers in New Zealand who are prompted to choose a country for their modem
should choose the “Australia” country code setting.
31
4-0938.UMpos 9/28/99 1:51 PM Page 31