Select Increments Dash-Pod - Manual (Page 2)

’97-’00 models must remove the section
of metal bracket on the driver and
passenger sides…
The quickest and easiest way to do this is
with a good pair of tin snips. There are
small notches in the metal that act as
perfect starting points for the snips. It
takes a little muscle, but good snips
can do the job.
’97-’00 models now check the pods for
fitment …may need to use a pair of pliers or
vice grips to slightly bend the corners back
and away if these points are interfering with
the pod(s) installation after making the cuts.
Then go to step #13 on other side of page.
Images are of Driver Side, repeat for Passenger Side.
There is a video of this on our website and on youtube.com
Other Pods that will fit your TJ Wrangler:
www.selectincrements.com