Bosch WFMC3301UC - Manual (Page 6)

6
On the rear of the appliance:
- Power cord with plug.
C = cold water connection
H = hot water connection
Useful tools
The following tools are helpful:
- Flat head screwdriver.
- Closed wrench (1/2"/13mm).
- Bubble level.
Dimensions
a = 27.0 inches (686 mm)
b = 30.7 inches (780 mm)
c = 37.0 inches (940 mm)
d = 16.0 inches (407 mm)
Door opening angle 180°
Approx. weight = 220 lbs (100 kg)
Installation area
d
WARNING
d
Never ground the washer to plastic
plumbing lines, gas lines or hot
water pipes.
This appliance must be installed on
a solid floor and well leveled due to
the higher spin speeds available. If
installing the machine on a wood
floor over a basement or on a
second floor, the floor may need to
be reinforced. Sound, vibration, and
risk of walking" will be affected
depending on the structure and
stability of the floor surface where it
is installed.
If the washing machine is to be installed
on a weak wood floor consider the
following:
q Soft floor surfaces, such as
carpets or surfaces with foam
backing, are not suitable. If
possible, place the washing
machine in a corner of the room.
q Screw a water resistant wooden
board (at least 3/4" thick) to the
floor.
q Secure the feet of the washing
machine with holding brackets.
Order the holding brackets (set)
from Bosch Customer Service
(WMZ 2200).
q Units are not designed to be
stacked.
q Units are not designed for under
counter installation
Pedestal Mounting
If mounting the washer on the Bosch
pedestal (accessory no. WTZ1295, for
colored variant, accessory no.
WTZ1295S) ) follow the instructions
supplied with the pedestal.
i Install pedestal prior to removing
transport bolts.
Closet
If installing the washer in a closet,
observe the minimum distances
according to the following table:
Minimum Installation Clearances
Closet
Sides 1/4" (6 mm)
Top 12" (3O5 mm)
Rear 2.5" (64 mm)
Front 1/4" (6 mm)
Ventilation:
Top: 48 sq. in (310 sq. cm),
Bottom: 24 sq. in (155 sq. cm)
Removing the transport
bolts
CAUTION
To avoid possible damage to the
appliance and adjacent surfaces, all
4 transport bolts must be removed
before using the appliance for the
first time and must be retained for
any future transport (e.g. when
moving).
q Release screws using the 1/2"
wrench provided until they can be
moved freely.
q Completely remove all 4 transport
bolts (bolt, spring, washer and bushĆ
ings) by reaching through the open
washing machine door and pulling
the drum slightly forward to loosen,
then pull out from the back.
q If the bushings do not come out
when removing the screws, place
screws back into the bushings and
carefully try again. It is important to
do this with the screws, otherwise
the bushings will not come out propĆ
erly.
q Insert the covers until they snap in
completely.
Storing the transport bolts
Always keep the transport bolts for fuĆ
ture transportation of the appliance
(such as when moving out).