SCT iTSX (Ford 4015,GM 4416) - Manual (Page 7)

SCT PERFORMANCE, LLC.
User’s Manual
2. GETTING STARTED
2.1 Powering on the iTSX
Installing the iTSX App:
The iTSX App is a free download from the Apple App store on your iPod, iPhone or iPad device.
1. To install the iTSX App on your mobile device, search the Apple App store for the phrase "iTSX".
2. Once located, touch the "Install" button within the store to automatically download and install the iTSX App.
iTSX Installation & Setup:
There two ways to power on the device. If you’d like to flash you vehicle, you will need to use the Vehicle instructions
below. If you are looking to update or load custom tunes onto your device you will use the Computer instructions
below.

Using the Vehicle
 Locate the vehicle’s OBD Diagnostic port. This connector is usually located under the vehicles dash
board on the driver’s side. The port may be covered with a cap or compartment door labeled OBD
Diagnostic Port.
 If the connector pins are covered or the port is located behind a compartment door, remove the cap or
open the compartment door.
 Connect the OBD connector from the Livewire TS to the vehicles OBD Diagnostic port.

Using the Computer
 Install SCT Device Updater before connecting your unit via USB (
Updater Download )
 Locate the computers USB port. This port can be found on the front or the back of the computer, if using
a laptop the ports will usually be on either side of the laptop.
 Using the USB cable provided connect the USB end of the cable to the PC and the other to the bottom of
the Livewire TS