SCT Xcalibrator 2 DCX (9550) - Manual

Xcalibrator 2 DCX User Instructions
Read This in Its Entirety Before Using!
Thank you for your purchase of the Dodge/Chrysler (DCX) Xcalibrator 2, this tool
has been designed to allow you to load performance tunes into your OBDII DCX
Vehicle, with the ability to return to your stock tune if desired for dealer visits.
Whenever you take your vehicle in for service, if modifications permit, always flash
the vehicle back to stock tune file.
How to use the Xcalibrator 2:
Plug the OBD-II connector into the port under the dash of the vehicle you wish to
program. Some vehicles may have a panel that needs to be removed to access it.
With the key off, use the up and down arrows to navigate through the main menu.
Menu options include:
Program Vehicle:
Custom Tune Choose custom tune to
Program into vehicle
Return to Stock Available after vehicle is
Programmed
DTC/Data Menu:
Read DTCs Display trouble codes
Clear DTCs Clear all DTCs
Battery Voltage Displays OBD2 port voltage
Read ECM Info Displays PCM part number
and vehicle VIN number.
Display Dealer Info: Displays opening message screen
LCD Contrast:
Sel to Save Adjusts LCD contrast
Device Info Displays Firmware and Serial number.
Vehicle Diagnostics:
The Xcalibrator 2 can read and clear DTCs (Diagnostic Trouble Codes) on the LCD
display. This feature will work on any supported DCX based OBD2 vehicle.
The Xcalibrator 2 can also read the PCM Part number of the vehicle, this part
number is necessary to allow our software to open your factory file as a starting
point.
2
Program Vehicle Menu:
The first menu is the Program Vehicle menu.. Here you can select what file
you want to load onto your vehicle. You will get a menu Tune Vehicle, or
Return to Stock.
In the Tune Vehicle menu, use the up and down arrow
keys to select the file you want to program onto your vehicle. With that file
displayed, press the select button to start the flashing process. During the course
of the flashing process, you may have to press select, or turn the key on/off.
Follow the directions on the LCD display.
Sample Programming Sequence, 2004-5 SRT-4:
Program Vehicle Press Select
SEL to Begin
Choose option, Tune Vehicle, or Return to Stock, then press select
Tune Vehicle
SEL to Begin
Return to Stock
SEL to Begin
Once you press select, you will be prompted to turn the key on
Turn Key On
Leave Engine Off
Due to the nature of the Dodge PCM, if you wait too long you will get an error.
Error 14 – SCI
ERR
Scroll up and down to select tune file to load into vehicle, these names are
programmed from our software, so names will vary. Press select once you have
selected the tune file you want to load
SCT Tune 1
Once you have selected the tune, you may be prompted to turn the key off
Turn Key Off
Press SELECT
Turn Key On
Leave Engine Off
If you wit too long to turn the key on may get an error
ECM Unlock Failed
3