PureFlow AirDog DF-200 - GM Duramax 2001-2010 - Manual (Page 9)

9
PureFlow AirDog
AirDog
®
II 2001-2010 DuraMax Diesel
Section 4 AirDog ® II & Mounting Brackets
Installing the AirDog
®
II & Mounting Brackets on the
Truck’s Frame!
Figure 2 Figure 3
4-1. Assemble the AirDog II mounting bracket to the frame bracket.
Figure 4 Figure 5 Figure 6
4-2. Use the spacer block to clear lines and wiring harnesses on the frame. Adjust the
assembly up or down on the frame bracket as necessary for clearance.
Out to ENGINE FUEL IN
4-3.
Install a 1/2” male J2004 quick connect x 3/8”
NPTF (08J2044-3/8NPTF) into the “ENGINE”
and “FUEL IN” ports in the AirDog II.
Figure 7
4-4. Install the 3/8” male J2004 quick connect x 1/8” NPTF (06J2044-1/8NPTF) into the
“TANK” port of the AirDogII. This is the smaller port next to the port marked
“ENGINE”.
Figure 7a
WARNING: The NPT fitting threads must be lubricated with oil or anti-
seize compound before installation to prevent galling!
4-5. Attach the AirDog II
®
to the completed bracket assembly as shown in
figures 4 and 5 . Figure 8