PureFlow AirDog DF-165 - GM 1992-2000 - Manual (Page 13)

13
AirDogII
®
1992-2000 Chevy Diesel
Section 5B Fuel Lines
Installing the
Fuel Supply Line from the fuel tank to the AirDog
®
5B-1. Cut the steel fuel line that goes to the engine and
install a 3/8” compression fitting with a 3/8” NPT female x
-8 JIC on the end of that line.
Figure 18
5B-2. Insert the female quick connect end (see figure 19) of the “Suction Hose Assembly” to
the male fitting installed in the “Fuel In” port during step 4-3 of this manual. A “click”
will be heard when the fitting is properly connected.
Figure 19
5B-3. Measure and cut the length of the “Suction Hose Assembly” necessary to reach the fitting
on the end line referenced in step 5B-1.
5B-4. Install a straight -8 swivel x 1/2" Push Lock fitting on each end of that fuel line.
Lubricate the barb end of
Push the fuel line completely
the Push Lock fitting with oil. onto the barb end of the fitting.
Figure 20 Figure 21
5B-4. Connect the fuel line to the respective fittings on the AirDog
®
and the fuel line from the
tank.
Figure 22