PureFlow AirDog DF-165 - GM 1992-2000 - Manual (Page 11)

11
AirDogII
®
1992-2000 Chevy Diesel
Section 5 Fuel Lines
Installing the AirDog
®
Fuel Supply Line to the Engine
5A-1. Remove the factory electric fuel Pump
mounted on the driver’s side frame rail.
Figure 11
NOTE: Assemble the compression fitting
to the -8 JIC flare fitting.
5A-2. Cut the steel fuel line that goes to the engine and
install a 3/8” compression fitting with a 3/8” NPT female x
-8 JIC on the end of that line.
Figure 12
5A-3 Insert the female quick connect end (see figure 12a)
of the “Pressure Hose Assembly” into the male quick
connect fitting previously installed in the port marked “ENGINE”.
You will hear a “click” when it connects.
Figure 12a
5A-4. Measure and cut the length of the “Pressure Hose Assembly” necessary to reach the
fitting on the end line referenced in step 5A-2.
Figure 13 Figure 14