PureFlow AirDog RP-150 Replaces High Pressure Pump - 7.3L Ford 1999-2003 - Manual (Page 12)

12
Raptor™ 100 & 150
1999 - 2003 Ford PowerStroke
Section 6 Electrical Harness
Figure 13
Installing the Raptor™ Fuel Pump wiring harness
.
Ground Wire
Hot Lead
The Raptor™ wiring harness.
Water Proof Fuse
Raptor Pump Lead
Figure 13
6-1. To connect the Power Supply Lead to the Raptor™. Insert the 2 pin Deutsch connector on
the end of the wiring harness into the corresponding connector on the Raptor™.
Figure 14
6-2.
Route the Raptor™ 'activation lead', to the fuse panel on the dash to the left of the
steering column. Attach the spade connector into a spare fuse holder on the panel that is
“hot” when the starter key is turned to the on position. Or connect it to the High Pressure
Pump Lead.
Figure 15
Figure 16
6-3. Connect the Black (-) wire to an adequate ground.
BE SURE TO PROPERLY SECURE THE WIRING HARNESS TO THE VEHICLE.