PureFlow AirDog RP-150 Replaces High Pressure Pump - 7.3L Ford 1999-2003 - Manual (Page 10)

10
Raptor™ 100 & 150
1999 - 2003 Ford PowerStroke
Section 5-A Fuel Lines
Raptor High Pressure Fuel Line to the Engine.
5A-1. Disconnect the high pressure fuel supply line to the engine from the OE fuel pump.
This pump is located on the driver’s side inside frame rail.
High Pressure Fuel Pump with 5/16” Quick Connect Fitting
To Engine
Figure 5 DISCONNECT HERE Figure 6
View from Front View from Rear
5A-2. Insert the female quick connect end (see figure 7) of the
“Pressure Hose Assembly” into the male quick connect fitting
previously installed in the port marked “OUT”. You will hear a
“click” when it connects.
Figure 7
5A-3. Connect the other end of the “Pressure Hose Assembly” (Figure 8) to
The original factory engine supply line shown in figures 5 & 6. It too will “click” when
properly connected.
Figure 8
5A-5 Any excess fuel hose can be addressed by routing the hose in a fashion to take up the
extra length, or a section of the hose can be removed. Push lock splices have been
included if you choose to remove the excess hose.
NOTE: The OE fuel pump and fuel line from the fuel tank may be removed from the
vehicle at this time, if desired.