PureFlow AirDog RP-150 - 7.3L Ford 1999-2003 - Manual (Page 10)

10
Raptor™ 100 & 150
1999 - 2003 Ford PowerStroke
Section 5-A Fuel Lines
Fuel Supply Line from the Raptor to the High Pressure
Pump.
Remove the original factory fuel supply line at the electric OE lift pump, located on the driver’s
side inside frame rail by squeezing the tabs on the end of the connector together. Push the quick
connect fitting toward the OE lift pump while firmly depressing the tabs. With the tabs
depressed, pull the fitting assembly from the inlet tube. Use care to hold the quick connect fitting
squarely onto the inlet tube. It may be difficult to disconnect the fitting if it becomes cocked
during removal.
With 5/16” Quick Connect Fitting
Figure 5 Figure 6
5A-1. Measure and cut the length of line on the “Pressure Hose Assembly” required to connect
the 'Fuel to Engine' port on the Raptor to the PowerStroke high pressure fuel pump.
5A-2. Assemble the ¼”Female NPT x ½” push lock to the 5/16” Quick Connect fitting.
Figure 7 Figure 8
5A-3. Insert the push lock quick connect assembly into the cut end of the hose. Oil can be used
on the barb to ease the installation.
Figure 9 Figure 10