PureFlow AirDog FRRP-100 - Dodge Cummins 1998.5-2002 - Manual (Page 8)

8
INSTALLING THE FRRP-100 CONTINUED
7. Cut the open end of the “Output Hose Assembly” to the desired length (a section of hose
and a hose splice have been included if additional hose length is required) and install the
½” push lock x -8 swivel (part# 4A-1-09-08-08-B) into the end. See Figures 6 & 7
Figure 6 Figure 7
Lubricate the fitting with oil. Push the hose completely on the barb.
8. Loosely install the male end of the 90° elbow (part# 4A-2-04-08-08-S) on the hose
assembly.
9. Loosely install the female end of the 90° to the outlet fitting of the FRRP previously
installed in step 3.
10. Route the hose assembly in a fashion to prevent kinking or chaffing.
11. Tighten the connections that were left loose in steps 8 and 9.
12. Connect the factory power lead to the lead from the motor of the FRRP-100.
INITIAL START PROCEDURE
1. Turn the starter key to the on/run position.
Note: It may be necessary to bump the starter for the ECM to energize the Raptor™
FRRP-100 Fuel Pump.
2. While the Raptor™ FRRP-100 Fuel Pump is on, bleed the fuel line to the filter
canister by disconnecting the quick connect at the canister. As soon as the line is
purged of air and fuel is observed, quickly reinstall the female quick connect. A click
will be heard when properly installed.
3. Start engine!