PureFlow AirDog RP-150 - Dodge Cummin 2003-2004.5 - Manual (Page 13)

13
PureFlow AirDog
Raptor
™ 100 & 150
2003
– 2004 Dodge Cummins
Section 6 Electrical Harness
The Raptor™ Fuel Pump is equipped with a relay controlled wiring
harness that is activated through the OE fuel pump connection.
Figure 16
Securing the Relay and Fuse Holder to the Vehicle.
6-1. Secure the relay and fuse holder to the vehicle on the firewall near the steering column or
a more suitable location, if appropriate.
Figure 17 Figure 18
Connecting the Raptor™ to the ECM Lead.
6-2. Disconnect the OE fuel pump lead at the ECM connector (Deutsch two pin connector).
Carefully route and connect the Raptor™ ECM lead (Deutsch, two pin Connector) to the
ECM pump lead. This lead can be found behind and below the stock filter canister in
the same location as the stock pump.
Raptor™ Wiring Harness Pump Lead
Ground Wire (-)
Hot Lead (+)
Deutsch ECM Lead
Deutsch Pump Lead
Relay
Figure 19 Figure 20 Figure 21
6-3. Route the wiring harness lead with the Deutsch Pump Lead to the Raptor™. Connect the
pump lead on the wiring harness to the corresponding lead on the Raptor™.