Rubicon Express RE7133 User Manual
Page 4

Revised
9.3.13
Rear Installation:
1. Prepare for the rear installation by removing the following items from the rear of
the vehicle: Tires, shocks, brake line bracket from the frame only, and track bar
(frame end only).
2. With the items removed, lower the rear axle assembly and remove the coil
springs.
3. Install the lower bump stop pads, 86-RM22016 on the axle housing with the sup-
plied hardware.
4. Place the new coil spring spacer, RM40110 and factory coil isolator on top of the
stock coil. Raise into the upper coil mount and over the lower axle mount.
(photo 3)
5. Install supplied sway bar links, RE1158 to the outside of the sway bar and mount-
ing tab on the axle.
6. Install rear upper track bar bracket, 86-RM24053 using the supplied hardware
and spacer, 35-RM31023. (photo 4)
7. Install the previously removed rear sway bar end links on the front of the vehicle
in the factory link location.
8. Raise the axle into place and reinstall the factory shocks using the rear shock ex-
tensions, RE2004 at the frame mounting point or install the new rear shocks,
RXT2420B or RXJ714 using the supplied hardware.
9. Reinstall the factory track bar, and re-attach the brake line bracket to the frame.
(Photo #2)
(Photo #3)
(Photo #4)