Fast & Fluid TMHC PC - Manual (Page 7)

p7
© Fast & Fluid Management, TMHC manual
Safety instructions
General safety instructions
Attention! Before installing the equipment and setting it in operation,
please read this manual carefully. This is safer both for yourself and the
machine.
The manufacturer accepts no liability if the instructions below are not followed:
1. If the TMHC has been damaged (e.g. during transport), do not attempt to set it in operation. When in
doubt, contact either your supplier or the F&FM service departm ent.
2. The equipment should be positioned and connected in strict accordance with the installation instruc tions.
3. All local safety regulations and ordinances should be observed.
4. The machine may be connected only to a 230V/16A/50Hz or 110V/25A/60HZ earthed wall soc ket
installed in accordance with the regulations.
5. Users should see to it that the machine is kept in good condition. Defective components should be
replaced by qualified personnel only.
6. In order to prevent physical injury, the doors should be c losed and the paneling fitted during norm al
use.
7. All service activities (other than routine maintenance and adjustments) may only be c arried out by
qualified technicians. See to it that the m ains lead is always kept unplugged while repairs are being
carried out.
Attention! When encountering a malfunction or error, always try
resetting the machine first before opening the front door. This can be
done by switching the machine off and back on.