L.B. White FA-MCS-D User Manual
Page 11
■
Press the center soft key EDIT. The following screen will be
displayed.
FIG. 20
■
Using the up/down keys, select either “‘ENA” to enable the
manual override or “dSA” to disable the override.
ENABLE (Manual Mode)
-- If enable is selected, press the right soft
key NEXT and then up/down keys to set the
temperature that will be maintained by the
SmartBox
™
.See Fig.21.
-- Once the temperature has been selected , press the
left soft key DONE.
-- The system is now in manual override. After
ensuring the room controller and Smart Box
™
set points are aligned, no further action is needed.
FIG. 21
DISABLE (Operating on Temperature Curve)
-- Selecting disable deactivates the manual override,
allowing the SmartBox
™
to operate within the
temperature curve.
-- Press the left soft key DONE to continue set-up.
-- Press the right soft key NEXT. The following screen
will be displayed.
FIG. 22
■
Press the right soft key NEXT to continue set-up. The
following screen will be displayed.
SET CLOCK
FIG. 23
■
Press the center soft key EDIT to set the clock.
-- Starting with the Month, use the up/down keys to
select Month, day, year, hour, (Note; AM or PM) and
Minutes.
-- Press left soft key DONE to return to SET CLK.
■
Press the right soft key NEXT to continue set-up.
TEMPERATURE SENSORS
■
The following screen is displayed. There are two
temperature sensors for each zone. This screen gives
you the option of either using both sensors for the
zone or removing one sensor. YOU MUST USE AT LEAST
ONE SENSOR.
FIG. 24
■
Press the center soft key EDIT.
■
Press the up/down keys to enable (ENA) or disable
(dSA) Temperature Sensor 1. See Fig. 25.
FIG. 25
11