Assembly, Safety rules – Steele Products SP-PM200M User Manual

Page 2

SAFETY RULES

IMPO

TANT! Some of the following symbols may appear on

this tool. Study them carefully and learn their meaning.

Proper interpretation of these symbols will allow for better and

safer operation of the tool.

• Never place hands, fingers, or feet inside the reel. Although

this mower is not powered by a motor, the reel spins when the

wheels turn, and it is sharp enough to cause serious injury.

• Never mow the grass when it is wet enough to be slippery.

• Do not use the reel mower while barefoot or while wearing sandals.

• Walk slowly. Do not run. Always make sure of your footing when

using the reel mower.

• Do not intentionally strike or ram trees, fences, etc. Doing so

may cause injury or may severely damage the reel mower

mechanisms.

• Verify that the reel mower is in proper operating condition. Do not

attempt to operate the reel mower if it is damaged. Have it repaired

before using.

- 3 -

ASSEMBLY

ASSEMBLING THE HANDLE

op handle

2. Center handle pieces

3. Left lower handle

4. Right lower handle

5. Foam grip

6. Long bolts

7. Flat washer

8. C-clip

9. Knob

Fig 1

Tools Required

Pliers (Not included)

ASSEMBLY INSTRUCTIONS

Refer to Fig 1.

This product normally requires 6 to 10 minutes for assembly.

NOTE: Do not tighten the

bolts completely until all

bolts have been inserted

through the holes in the

handle pieces.

1. Insert the 2 center handle pieces into the left and right sides of

the top handle, and secure them in place using screws.

2. Connect the right lower handle to the left lower handle, and

secure using two 1 3/8” long bolts and hex nuts (provided).

3. Attach the top handle assembly to the lower handle assembly

using four 1 3/8” long bolts and hex nuts (provided).

4. Tighten all of the hex nuts on the joints of the handle assembly.

- 4 -