Steele Products SP-GMK049 - Manual (Page 15)

STARTING
1. Fuel Mixture
Use a 2% or 4% (50:1 or 25:1) oil/gasoline mixture (Fig.10)
(Please use fuel mixture of 25:1(gasoline:oil) 20 hours before the
the machine runs.)
Warning!
2-stroke engines have high specific horsepower and we
recommend the use of regular or super unleaded gasoline, with or
without lead and an octane rating of no less than 90.
When preparing the mixture, only use oil for two stroke engines. Shake
the fuel mixture container before filling the tank. (Fig.11) Page 4.
Refill when the engine is switched off and far away from sparks or
flames.
Before unscrewing the fuel tank cap, position the power drill on a flat,
solid surface to prevent fuel spills.
Gasoline is highly flammable.Refuel outdoors only.
Never add or replace fuel when the engine is in operation or before the
engine stops.
Do not leave the mixture in the fuel tank or in a fuel canister for a long
period of time.
Do not start the engine if fuel leakage is found.
2. Starting The Engine
a) Put switch (I ,Fig.14) Page 5. in the “START” position.
b) Put the choke lever (M, Fig.15. Fig.16) Page 5. in the “CLOSE” position.
c) Push the primer bulb (L, Fig.12. Fig.13) Page 5. a few times until the
fuel comes out of the fuel tube.
d) Pull the starter rope (N ,Fig.17) Page 5. a few times until the engine
starts.
e) Put the choke lever (M , Fig.15. Fig.16) Page 5. back to the original
position “OPEN”
13