Steele Products SP-GG900E - Manual (Page 18)

Owner’s Manual
17
Operation
Powering 120 Volt AC Tools And Equipment:
1. Prior to powering tools and equipment, make sure the generator’s rated voltage, and amperage capacity
(120V AC) is adequate to supply all electrical loads that the unit will power. If powering exceeds the
generator’s capacity, it may be necessary to group one or more of the tools and/or equipment for connection
to a separate generator.
CAUTION: Attempting to power sensitive electronic equipment without the use of an approved
line conditioner may cause damage to the equipment. Steele® is not responsible for any direct or indirect
damage caused by failure to use an approved line conditioner.
2. Once the generator is running, simply connect the power cords of 120 volt AC powered tools and
equipment into the 120 volt AC dual outlets.
NOTE: The generator features an AC non-fuse circuit breaker to protect the AC circuit in case of an
overload. Should an overload occur, the breaker will “trip” to its “off” position, In this case, refer to above in
this position. Then, reset the circuitry system by turning the circuit breaker to its “on” position.
3. Disconnect all electrical powered tools and equipment from the generator’s 120 volt AC duel outlets.
4. After the engine and generator have completely cooled, store generator in a safe, clean, dry location (if
not already installed).
Powering 12 Volt DC tools and Equipment:
1. Prior to powering tools and equipment, make sure the generator’s rated voltage, and amperage capacity
(12V DC) is adequate to supply all electrical loads that the unit will power. If powering exceeds the
generator’s capacity, it may be necessary to group one or more of the tools and/or equipment for connection
to a separate generator.
2. Connect the power cord of a 12V DC powered tool or equipment to the DC Terminals.
CAUTION: Make sure to connect the positive (+) lead of the power cord to the positive (+) terminal on
the generator, and connect the negative (-) lead of the power cord to the negative (-) terminal on the
generator.
3. Start and run the engine as described above.
4. When finished using the generator, turn the engine power switch to its “OFF” position. Turn the fuel valve
to its “OFF” position.
5. Disconnect the electrical powered tools’ power cord from the generator’s DC terminals.
6. After the engine and generator have completely cooled, store the generator in a safe, clean, dry location
(if not already installed in one).
NOTE: The 12V DC is generally used for charging batteries.