Steele Products SP-GG900E - Manual (Page 16)

Owner’s Manual
15
Operation
NOTE: The parts listed above are
helpful for locating the controls mentioned
below.
CAUTION: Prior to first using the generator, the
engine must be filled with a high quality sae 10w-30
grade engine oil. To do so unscrew and remove the
engine’s oil dipstick located at the bottom of the
engine crankcase. Fill the engine’s crankcase until the
oil level is level with the upper marked line on the
dipstick. Then, screw the dipstick back into the oil fill
hole.
ENGINE OIL RECOMMENDATIONS
Oil is a major factor affecting performance and service life. Use 4-stroke automotive detergent oil.
SAE 10W 30 is recommended for general use. Other viscosities shown in the chart may be used when the
average temperature in your area is within the recommended range.
Before Starting the Generator
1. Check that the engine power switch is in its “OFF” position (see diagram on next page).
2. Before the first use, remove the fuel tank cap and fill the fuel tank with unleaded gasoline. When fueling,
be sure that the fuel strainer is in place. Replace the fuel tank cap. Thereafter, check the engine’s fuel gauge
for the amount of unleaded gasoline in the fuel tank. If necessary, refill the fuel tank with unleaded gasoline.
The generator must be turned off and cooled down before refilling the fuel tank.
AMBIENT TEMPERATURE
-20
-20 0 20 40 60 80 100°F
-10 10 20 30 40°C 0
5W-30
10W-30
30
SAE Viscosity Grades
Control Panel
Electric Start
Upper Level
Oil Fill and
Dipstick
Fuel Tank