ARB 0750001B - Manual (Page 3)

1 Introduction
ARB DIFFERENTIAL COVERS
1.2
Model Range
• Available for most standard Dana 60, Dana 44, Dana 35, and
Dana 30 axle assemblies.
ARB Part # APPLICATION(s)
0750001 Dana 60 and Land Rover Salisbury
0750002 Dana 30
0750003 Dana 44
0750004 Dana 35 and Dana 35C
1.2
Features
• High tensile solid nodular iron structure (tougher and harder
than solid carbon steel) protects the differential and ring &
pinion set from the obstacle impact hazards of competition
rock crawling, or extreme off road trails.
• Computer optimized cross brace design adds more than 1300
Nm/deg [960 ft-lb] of torsional rigidity to the entire axle
assembly. This increased flexural strength in the housing
helps keep the ring & pinion gears meshing on the flat faces of
the teeth, which greatly increases ring & pinion life and overall
maximum load strength.
• Carrier bearing life is prolonged, especially on high output
vehicles, by the improved support given to the bearing
alignment.
• Low-profile shape of the outside surface helps maximize the
running gear clearance around the cover.
• Maximized approach / departure angled exterior surfaces help
to minimize rock / obstacle hang-ups.
• High tensile cap screws (supplied with the kit) are recessed
into the cover to protect them from contact with obstacles
which might damage or loosen them.
• Low profile drain plug design resists damage from obstacle
contact.