ARB 3432060 - Manual (Page 2)

28/10/04 Page 2 of 5 3782592
BULL BAR FITTING KIT No 6171306/07
USE PART No QTY DESCRIPTION
IMPACT ABSORBER TO 3751759 1 IMPACT ABSORBER LHS
BULL BAR 3751761 1 IMPACT ABSORBER RHS
6151045 8 M10 25mm BOLT
4581048 8 M10 SPRING WASHER
4581041 8 7/16" FLAT WASHER
IMPACT ABSORBERS TO 6151243 2 M10 X 130mm BOLT
CHASSIS 6151026 2 M10 NUT
4581048 2 M10 SPRING WASHER
6151081 4 7/16 X 4.5" BOLT
6151124 4 7/16" NUT
4581042 4 7/16" SPRING WASHER
4581041 12 7/16" FLAT WASHER
NUMBER PLATE TO BULL BAR 6151017 2 M6 x 16mm BOLT
6151046 2 M6 FLAT WASHER
6151128 2 M6 FLANGE NUT
WING RETURN TO UNDER- 6151180 2 M6 x 20mm BOLT
GUARD PLASTIC TRIM 6151046 2 M6 FLAT WASHER
6151128 2 M6 FLANGE NUT
3500200 1 BUFFER KIT
3500080 1 ARB INDICATOR KIT (CONTAINS LEFT AND RIGHT)
180302 8 CABLE TIE
FOR THE WINCH BULL BARS ONLY
USE PART No QTY DESCRIPTION
8-9000lb WINCH
10-12,000lb WINCH 4581041 8 7/16" FLAT WASHER
CONTROL BOX BRACKET 3751694 1 CONTROL BOX BRACKET
TO BULL BAR 6151021 2 M8 X 20mm BOLT
6151132 2 M8 FLANGE NUT
4581044 2 M8 FLAT WASHER
CONTROL BOX BRACKET 6151068 2 1/4" X 1" BOLT
TO BULL BAR FOR THE 6151118 4 1/4" NUT
10,000 AND 12,000 LB WINCH 4581035 4 M6 FLAT WASHER
BLB560 2 BATTERY LEAD BLACK
BLR560 1 BATTERY LEAD RED
6151045 2 M10 25mm BOLT
LOCKING BOLT HARDWARE 4581048 2 M10 SPRING WASHER
4581041 4 7/16" FLAT WASHER
6151026 2 M10 NUT
TOOLS REQUIRED
Basic tool kit, level, tape measure, drill, 6mm and 10mm drill bits.
FITTING PROCEDURE
1. Undo the fasteners retaining the bumper bar and aluminum chassis extensions and slide forward sufficient to
disconnect the headlight washer hose at the washer bottle, then remove the bumper bar.
2. Remove the headlight washers and hose from the bumper bar and fit to the bull bar. Make sure the tubing is fed
through the bull bar then cable tie in place.
3. Fit the turn signal indicators supplied into the bull bar. NOTE: Refer to the instructions supplied with the turn
signal indicator kit.
4. WINCH BARS: FITTING THE 8 OR 9,000lb WINCH
A. Fit the control box to the control box bracket using the two 1/4” nuts, washers and spring washers. Bolt the
control box bracket to the bull bar using the M8 x 20mm bolts, flat washers and flange nuts supplied. Refer to
Diagram 1.