ARB 3413190 - Manual (Page 3)

29/04/08 Page 3 of 13 3786407
1. Remove the bumper bar and grille
from vehicle.
2. Remove the cross member bracket
and tow brackets and tie downs.
Remove the 4 front 8mm bolts that
secure the vehicle stone tray.
3. To fit chassis brackets to chassis rails,
cut off the lower section of chassis
mount.
4. Mark out a line level with the bottom
of chassis rail, and cut off using a
hacksaw or a angle grinder and touch
up bare metal with paint.
5. Fit chassis brackets to vehicle and
secure as follows.
6. On RHS of vehicle, refit tie down
bracket, tow hook, original 14mm
long bolts and washers to underside
of chassis bracket, finger tighten
only.
Note: Swap tie down brackets left to
right so they mount as shown.