ARB 3410100 - Manual (Page 6)

FITTING PROCEDURE
7. Using a 12mm drill bit, drill two new
holes in the roller fairlead 20mm below
the original holes.
8. Fit the roller fairlead to the bar using
two 3/8” x 1 ¾” bolts, M10 flat and
spring washers. Tighten all winch bolts.
9. Fit the control box to the control box
bracket using the nuts and washers that
came with the winch kit.
10. Wire the control box to the winch
according to the instructions provided
with the winch.
Original
New hole
Drill the new
hole 20mm
below original
Last Rev Date: 26/05/2006 Page 6 of 9 Fitting instructions# 3783204
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd