ARB RD127 - Manual (Page 10)

2 Removing the Existing Differential
8
2.6 Removing the differential carrier
Remove the adjuster nut locking tabs.
Remove the bearing caps from the third member.
Remove the adjuster nuts.
Carefully remove the differential carrier from the third member.
Remove the tapered roller bearings from the differential carrier with
a bearing puller. (Fig.3.)
HINT :
Check the condition of the bearing for wear and
replace if necessary.
Figure 3.
NOTE : On vehicles which employ smaller bearings No.
2788/2729, replacement bearings 11162/11300 are
required. Also, when changing bearings be sure to
use only genuine Timken bearings. It has been found
that other brands have a different cage which may foul
on the seal housing.