JLG Telehandler Personnel Work Platform - Manual (Page 35)

Section 5 - Emergency Procedures
5-1 31200160
SECTION 5 - EMERGENCY PROCEDURES
5.1 EMERGENCY LOWERING OF BOOM
In the event of total loss of engine power, hydraulic pump failure or if platform or
boom becomes jammed or snagged in overhead structures or equipment with an
elevated load, the situation must be properly evaluated and dealt with on an
individual basis. Contact your local Authorized Distributor or JLG Service
Department for specific instructions.
Secure the telehandler using the following procedures:
1. Rescue platform occupants.
2. Clear the area around telehandler of all personnel.
3. Engage the parking brake. Place the transmission control lever in “NEUTRAL”.
4. Block all four wheels.
5. Section off a large area under the boom with string or tape to restrict any
personnel from entering this area.
5.2 INCIDENT NOTIFICATION
JLG Industries, Inc. must be notified immediately of any incident involving a JLG
product. Even if no injury or property damage is evident, the factory should be
contacted by telephone and provided with all necessary details.
In USA:
Toll Free: 1-877-JLG-SAFE (1-877-554-7233)
8:00am to 4:45pm EST
Outside USA:
Phone: +1-717-485-6591
E-mail:
[email protected]
Failure to notify the manufacturer of an incident involving a JLG Industries product
within 48 hours of such an occurrence may void any warranty consideration on that
particular machine.
Important:
Following any accident, thoroughly inspect the machine and test all functions from
cab controls. Do not lift above 10 ft (3 m) until all damage has been repaired, if
required, and all controls are operating correctly.