JLG Telehandler Personnel Work Platform - Manual (Page 27)

Section 3 - Operation
3-1 31200160
SECTION 3 - OPERATION
3.1 PLATFORM OPERATION
• JLG recommends the user comply with local, provincial and federal regulations
as they pertain to telehandler mounted personnel work platforms.
• Capacities and range limits for the telehandler change depending on the platform
in use.
• Separate attachment instructions must be kept in manual holder in cab with this
Operation & Safety Manual. An additional copy must be kept with the attachment
if it is equipped with a manual holder.
• For fork mounted platforms, the combined weight of the platform, load and
personnel shall not exceed one-third of the capacity at the related load center
position as indicated on the capacity chart for the attachment on which the
personnel work platform is being used.
Lifting/Lowering Personnel
• Secure work area.
• Without personnel in the platform, perform a simulated lift with designated signal
person on ground as spotter to assure adequate telehandler range and
attachment clearances.
• With the park brake applied, lift/lower personnel only at their request and in
accordance with the requirements set forth in Section 1 - General Safety
Practices and Section 4 - Types of Personnel Work Platforms. The operator shall
always sound horn to alert personnel prior to lifting/lowering the platform and
operate the joystick slowly and cautiously.