Briggs & Stratton PRO6500 - Manual (Page 6)

6
BSPP Generator
ASSEMBLY
Your generator requires some assembly and is ready for
use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-800-743-4115.
Remove Generator From Carton
1. Set carton on a rigid flat surface with “This Side Up”
arrows pointing upward.
2. Carefully open top flaps of shipping carton.
3. Cut down corners at one end of carton from top to
bottom and lay that side of carton down flat.
4. Remove all packing material, carton fillers, etc.
5. Remove generator from shipping carton.
Carton Contents
Check all contents. If any parts are missing or damaged, call
the generator helpline at 1–800–743–4115.
• The generator
• Generator owner’s manuals
• Engine owner’s manuals
• (2) Locking 30A plugs
• Battery charge cables
• Engine oil
• Wheel kit
Install Wheel Kit
The wheel kit is designed to greatly improve the portability
of your generator.
NOTE: Wheel kit is not intended for over-the-road use.
You will need a 1/2" or 13mm socket wrench and a 1/2" or
13mm open end wrench and a 7/16" socket wrench and
7/16" open end wrench and a needle-nose pliers to install
this kit.
NOTE: Adjustable wrenches may be substituted for open
end wrenches.
Refer to Figure 1 and install the wheel kit as follows:
1.
Place the bottom of the generator frame on a flat, even
surface.Temporarily place unit on blocks to ease assembly.
Support Leg
Nut
Axle
Flat Washer
Wheel
E-Ring
Figure 1 — Install Wheel Kit
20 mm Cap Screw
Nut 3/4” Cap Screw
Vibration Mount
Use existing hardware
to attach left side of
support leg to unit
Nut
Handle Pin
Handle
Flat Washer
Nylon Washer
45 mm Cap Screw
Nylon Washer
Your unit may vary slightly
from that shown here