Blaupunkt CM147 - Manual (Page 24)

24
CD Changer operation
Trouble Cause/Solution
CD play does not start. • Dusty or defective disc.
• The ambient temperature is more than 50
° C (120 ° F).
The disc cannot be loaded or is • The disc is inserted with the printed side downwards.
automatically ejected.
The sound skips due to vibration. • The changer is installed at an angle of more than 20 ° .
• The changer is not installed on the sturdy part of a car.
• Dusty or defective disc.
Error Displays
Display Cause Solution
“CD ERROR” A disc problem such as an upside Insert the disc correctly.
down or dirty disc, or a CD-ROM Clean the disc.
(computer) disc.
“NO DISC” No magazine or disc in changer Take out the magazine and insert the discs.
If the above mentioned solutions do not help to improve the situation, consult your nearest Blaupunkt dealer or
in the United States call 1-800-266-2528.
Troubleshooting Guide
The following check will assist in the correction of most problems which you may encounter with your unit. Before
going through the check list below, refer back to the connection and operating procedures.
General
Trouble Cause/Solution
No sound. • Adjust the volume with the + button.
• With a two-speaker system set the fader control to the center position.
Indications do not appear on the • Remove the front panel and clean the connectors. See
display window. “Cleaning the Connectors’’ of “Maintenance’’ for details.
Radio reception
Trouble Cause/Solution
Preset stations are not receivable. • The broadcast is too weak.
Automatic tuning is not possible. • The broadcast is too weak. —> Use manual tuning.
Travel Store feature does not complete • Not enough broadcast frequencies are receivable.
storing of six stations.
* Also make sure that antenna is connected, extended and dry inside.