Ubp16.bodypack.microphone.transmitter – Bogen UDMS16BP User Manual
Page 8

8
1. Open the BATTERY.DOOR.(30) by pulling on side tabs and swinging the lid open.
Insert two fresh AAA ALKALINE BATTERIES into the BATTERY.COMPARTMENT.
....(31)
, observing the correct polarity. Fresh alkaline batteries can last up to 5
hours in use, but in order to ensure optimum performance, it is recommended
that the batteries be replaced after 3-4 hours of use.
2. The UBP16 is provided with a 3.5 mm LOCKING.JACK.(33) for connecting the
audio input. Connect the LAVALIERE. MIC. CORD. (40) here. To secure the
connection, turn the slip ring on the plug clockwise to thread it on the jack.
To unplug, reverse the process. Slip the transmitter into a pocket or use the
CLIP.(32).on the rear of the unit to attach to your clothes.
3. Select Channel by turning the frequency rotary DIP.SWITCH.(39) to one of the
sixteen channels. The slot on the switch shaft should match a number or letter of
the dial, which indicates the selected channel. This channel needs to be set to
the same channel as the UDR16 Receiver.
(IMPORTANT NOTE: The transmitter
must be OFF when selecting a new channel. When selected, the transmitter will then be
at the new selected channel when turned ON. If you attempt to change the channel
when the transmitter is ON, it will not change until the unit is turned OFF and ON
again. This step must be repeated each time you select a new channel.)
4. Turn on the UBP16 by sliding the AUDIO.MUTE.SWITCH.(34) to the OFF position first,
then slide the POWER.SWITCH.(36) to the ON position. The bi-color LED.
....INDICATOR.(35)
will stay ON (green) indicating usable battery strength and
the transmitter is ON. In the case of dead or low batteries, the LED will either
not go on at all or will stay ON (red) continuously, indicating that the
batteries should be replaced with fresh ones. To preserve battery life, turn the
transmitter OFF when not in use. The A or B DIVERSITY.LED.INDICATORS.(14).
.
on the UDR16 receiver should now be lit, indicating that signal is being received
from the transmitter.
(Note: The UBP16 is supplied with a removable antenna (37). It should always be
operated with the supplied antenna. For optimum operating range, always maintain
line-of-sight between the transmitter and the receiver whenever possible.)
5..Microphone.Use
Secure the connection from the LAVALIERE. MIC. CORD. (40).To use the
lavaliere mic, attach it at chest level. Do not place it too close to the
mouth. A distance of about six inches usually works best. When ready to speak,
slide the AUDIO.MUTE.SWITCH.(34) to the ON position.
UBP16.BODYPACK.MICROPHONE.TRANSMITTER
- SEC4T 4" Compact 4W Ceiling Speaker BCWR Receiver ANS501 AMT-12 UTI312 OCS1 SAX1R Unbalanced Stereo Input Module C35 C100 C60 HFCS1 MB8TSQ 8" Metal Box Speaker HDO100 Handheld Omnidirectional Dynamic Microphone KFLDS30T 30W Wide-Dispersion Reentrant Horn Loudspeaker (Mocha) C100 Classic Series 100W Public Address Amplifier HDU250 Handheld Cardioid Dynamic Microphone HDU150 Handheld Cardioid Dynamic Microphone ADP1 Analog Door Phone - Two-way Terminal for Telephone Systems