Bogen UDMS16BP - Manual (Page 5)

5
5...Channel.Selection
Turn the frequency rotary DIP.SWITCH.(11) to one of the sixteen channels. The
slot on the switch shaft should match a number or letter on the dial, which
indicates the selected channel.
6..Audio.Level.and.Peak.LED.Indicator
The UDR16 receiver is equipped with a five segment LED.AUDIO.LEVEL.DISPLAY.
....(15) . Occasional flickering of the top Peak LED indicator on loud inputs to
the transmitter is normal. If this LED lights continuously, turn down the INPUT
LEVEL CONTROL on the transmitter, or noticeable distortion may result.
7..Connecting.the.Audio.Output
The UDR16 receiver provides both a fixed mic level BALANCED.MIC.AUDIO.
....OUTPUT.XLR.(7) and an adjustable line level AUDIO.OUTPUT.1/4”.jack.(10).
Tip = signal (+)
Sleeve = ground
Rear Panel XLR Unbalanced 1/4” Plug
(Note: As when making any connection, make sure the amplifier or mixing board
volume is at the minimum level before plugging in the receiver to avoid possible
sound system damage.)