LG V-C426*** - Manual (Page 4)

– 4 –
Please read all the following information,
which contains important instructions for
the safety, the use and the maintenance
of the appliance.
This appliance complies with the following
EC Directives: -73/23/EEC, 93/68/EEC-
Low Voltage Directive-89/336EEC -EMC
Directive.
■ Never allow children to use the
appliance unsupervised.
■ Do not use the appliance If the
supply cord is damaged or faulty.
■ If the supply cord is damaged, it must
be replaced by an approved LG
Electronics Service Agent to avoid a
hazard.
■ Always switch the vacuum cleaner off
before :
• changing the dust bag
• changing or cleaning the filters.
■ If no dustbag is inserted, the cover
cannot be closed. Please do not use
force!
■ Do not vacuum flammable or explosive
substances (liquids or gases).
■ Do not vacuum hot ash, embers etc.
nor sharp objects.
■ Do not vacuum water or other liquids.
■ Please make sure when using the
carrying starp that it is securely fitted.
■ The use of radio trans mitting devices
close to the appliance may interfere
the function of the appliance, input
power may be vary.
■ When you vacuum with an attachment
appliance that has a rotating brush
roller:
• do not reach into the running brush roller.
Connecting the flexible hose
Insert the hose holder (1) into the
suction opening.
When the hose (2) is to be disconnected
from the appliance, press the release
button (3) and pull the hose holder out
of the suction opening.
Assembling the tubes
• Telescopic tube (4)
- Hold spring latch (5)
- Pull out the tube to required length.
- Release spring latch to lock.
• Metal tube (4)
- Connect tubes to each other.
• Elbow tube is for cleaning under the
sofa, table and bed easily. (23)
- Connect the elbow tube to the
flexible hose and, connect the
telescopic tube to the elbow tube.
(You can also connect the telescopic
tube to the flexible hose without the
elbow tube.)
- If you pull the spring latch(22), the
elbow tube is bended. (23)
- If you stretch the elbow tube, it is
returned to its position.
Using the cleaning head and
Accessory Nozzles
Fit the large cleaning head onto the end
of the tube.
• The 2 position head (6) is equipped
with a pedal (7) which allows you to
alter its position according to the type
of floor to be cleaned.
Hard floor position(tiles, parquet
floors...). slide on the lever to lower
the brush.
Carpet or rug position. slide on the
lever to lift brush up.
• This device (24) is used with the suction
hole for device protection mounted. For
the suction hole for device protection, its
front, side and upper side is enclosed
with a soft material in order to prevent
damage of the device.
Connect the suction hole for device
Information for your safety
How to Use
■
■
Do not expose vacuum cleaner to heat.
Do not vacuum fine dust.
•
Turbine brush nozzle
Slide the air control lever to the right
for long type carpet and to the left for
short type carpet.
Press the button on the rear side of
the nozzle to separate the air cover.
Use the dusting brush & crevice tool
to vacuum clean the brush and fan.
- Air adjustment(20)
- Cleaning turbine brush nozzle(21)