Philips MC148C-37 - Manual (Page 15)

15
MC 148 / 37 page 15
English
6 To stop the tape, press STOP 9 on the set or remote
control.
• To reset the tape counter, press STOP 9 again.
Note: The sound source cannot be changed while recording
a cassette.
Switching cassette sides
The cassette side can be switched manually or automati-
cally before or during tape playback.
• Press SHUFFLE
SIDE A / B (SIDE/ ; or during playback only
2 on the remote control).
™ The display shows
SIDE A or SIDE B and the tape
counter resets to 000,
Reverse mode options
• Press REPEAT
REV MODE / BAND once or more to select your
option:
å
: playback stops at the end of the tape.
∂ : both sides are played once.
∫ : both sides are played repeatedly,
up to 5 times each side.
GENERAL INFORMATION ON RECORDING
• Recording is permissible insofar as copyright or other
rights of third parties are not infringed.
• For recording, use only NORMAL (IEC type I ) or CHROME
(IEC I I ) type cassettes on which the tabs have not yet
been broken.This deck is not suited for recording on or
METAL (IEC
IV ) type cassettes.
• The best recording level is set automatically. Altering
the VOLUME, INCREDIBLE SURROUND, DBB or
INTERACTIVE SOUND controls will not affect the
recording in progress.
• At the very beginning and end of the tape, no recording
will take place during the 7 seconds when the leader
tape passes the recorder heads.
• To protect a tape from accidental erasure, have the tape
in front of you and break out the left tab. Recording on
this side is no longer possible. If, however, you wish to
record over this side again, cover the tabs with a piece
of adhesive tape.
Synchro Start CD recording
1 Select CD source.
2 Insert a CD and if desired, program track numbers.
3 Press OPEN to open the tape door.
4 Insert a suitable tape into the deck and close the tape
door.
5 Press RECORD to start recording.
™ COPY or RECORD is displayed briefly and
RECORD
is shown during recording
– Playing of the CD program starts automatically from
the beginning of the CD/program after 7 seconds. It
is not necessary to start the CD player separately.
– If you wish, press CLOCK once to monitor the counter
display.
6 To stop recording, press STOP 9.
XP MC 148/37 01-02-2000 12:09 Pagina 15