Philips TP2797B - Manual (Page 32)

32
ANT "A"
75 Ω
L
AUDIO
R
AV
VIDEO
S-VIDEO 1
PIP ANT "B"
75 Ω
SURROUND SOUND
8 8
+ R – – L +
ATTENTION - TO AVOID DAMAGE
1. DO NOT CONNECT SURROUND SOUND SPEAKERS
TO A SEPARATE AMPLIFIER OR TO SPEAKERS
CONNECTED TO ANOTHER PRODUCT.
2. DO NOT CONNECT LEFT AND RIGHT SPEAKER
OUTPUT TOGETHER.
S-VIDEO 2
out
AV2
in
AV1
in
LOCATOR POWER
AV ON/OFF POSITION FREEZE TV
VCR
ACC
SWAP SOURCE PIP CH
UP DN
SMART
SOUND
SMART
PICTURE
MENU SURF
VOL CH
MUTE
CC STATUS CLOCK A/CH
EXIT TV/VCR
SLEEP TUNER
VCR
RECORD
A/B
MULTI
MEDIA INCREDIBLE
STEREO
24
4
ANTENNA OUT
ANTENNA
IN
VIDEO AUDIO
IN IN
OUT OUT
L R
AV 1
AV 2
1
2
3
The TV’s Audio/Video Input jacks
are for direct picture and sound
connections between the TV and
a VCR (or similar device) that
has Audio/Video Output jacks.
Connect the VIDEO (yellow)
CABLE to the VIDEO IN jack
on the back of the TV. Then con-
nect the AUDIO (red and white)
CABLES to the AUDIO (left and
right) IN jacks on the rear of the
TV (AV 1 or AV 2).
Connect the VIDEO (yellow)
CABLE to the VIDEO OUT jack
on the back of the VCR. Then
connect the AUDIO (red and
white) CABLES to the AUDIO
(left and right) OUT jacks on the
rear of the VCR.
Turn the VCR and the TV
ON.
Use the A/V button on the
remote to select the AV 1 chan-
nel.
With the VCR ON and a prere-
corded tape inserted, press the
PLAY button to view the tape
on the television.
AUDIO IN
(RED/WHITE)
VCR
(EQUIPPED WITH VIDEO AND
AUDIO OUTPUT JACKS)
S MART H ELP
An additional accessory
device can be hookup by
repeating the steps above using
the AV 2 inupt jacks.
VIDEO IN
(YELLOW)
H
OW TO
U
SE THE
A
UDIO
/V
IDEO
I
NPUT
J
ACKS
BEGIN
BACK OF VCR
NOTE: Repeatedly pressing the AV
button on the remote will toggle the
picture source from the current chan-
nel, to the last channel viewed, then
to the AV 1 connection, then to the
AV 2 connection.
This also applies to the Multi Media
button on the remote. Repeatedly
pressing the Multi Media button will
toggle the picture source from the
current channel to the last viewed
channel, then to the MM 1 (AV 1)
connection, then to the MM 2 (AV 2)
connection.
IF YOU ARE USING A
MONO DEVICE, USE
ONLY THE AUDIO R
JACK.
A UDIO /V IDEO I NPUTS
BACK OF TV
When using the Audio/Video AV 1 input jacks, the video and sound can be
viewed and heard on the AV 1 channel.
When using the Audio/Video AV 2 input jacks, the video and sound can be
viewed and heard on the AV 2 channel.