Philips AZ1138 - Manual (Page 17)

17
English
Problem Solution
No sound/ power – Volume not adjusted. Adjust the VOLUME.
– Power cord not securely connected.
Connect AC power cord properly.
– Batteries dead /incorrectly inserted.
Insert (fresh) batteries correctly.
Display does not function – Electrostatic discharge.
properly/ No reaction to Switch off and unplug the set.
operation of any of the controls Reconnect after a few seconds.
no d1SC, Cd Err or
– No disc inserted. Insert a disc.
nF d1SC indication/ MP3CD/ – Disc badly scratched/ dirty.
CD playback does not work Replace/ clean disc (see maintenance).
– CD-R(W) is blank or the disc is not finalized.
Use a finalized CD-R(W).
– Laser lens steamed up.
Wait until lens has recovered to room temerature.
– Incompatible format used for MP3. Check if your disc
format is ISO 9960, Joliet, finalized multisession.
The disc skips tracks – Disc damaged or dirty. Replace or clean CD.
– Prog
SHUFFLE mode.
ram/ SHUFFLE is active. Quit program/
Sound skips during – MP3file made at compression level exceeding 320 kbps.
MP3 playback Use a lower compression level to record CD tracks
into MP3 format.
Cannot find desired MP3 title – Wrong file extension/ used.
Change file extension to .MP3
Poor cassette sound quality – Dust and dirt on the heads, etc.
Clean deck parts, see maintenance.
– Use of incompatible cassette types (METAL or
CHROME). Only use NORMAL (IEC I) for recording.
Recording does not work – Cassette tab(s) may be broken. Apply a piece of
adhesive tape over the missing tab space.
If a fault occurs, first check the points listed below before taking the set for repair.
Do not open the set as there is a risk of electric shock. If you are unable to remedy a
problem by following these hints, consult your dealer or service center.
WARNING:
Under no circumstances should you try to repair the set yourself, as
this will invalidate the warranty.
Troubleshooting
XP AZ 1138/17 10-07-2001 18:42 Pagina 17