Philips HTS5580W-F7 - Manual (Page 23)

21
Set up network
1
Press (Home).
2
Select [Setup], then press OK.
3
Select [Network], then press OK.
4
Select and adjust the following settings:
• [Network Installation] : Starts
wired (Ethernet) setup. Follow the
instructions to set up the network
connection.
• [View Network Settings] : Displays
the current network settings.
5
Press OK to confirm your choice.
Set up EasyLink
1
Press (Home).
2
Select [Setup], then press OK.
3
Select [EasyLink], then press OK.
4
Select and adjust the following settings:
• [EasyLink] : Enables or disables
EasyLink.
• [One Touch Play] : Enables or disables
One Touch Play.
If enabled, you can use the remote
control to start disc play in the
home theater and the TV switches
automatically to the correct channel.
• [One Touch Standby] : Enables or
disables One Touch Standby.
If enabled, the home theater can
be switched off to standby by a
remote control from the TV or other
connected HDMI CEC devices.
• [System Audio Control] : Enables or
disables System audio control.
If enabled, follow the instructions on
the TV to map the connected devices
correctly to the audio connectors of
the home theater. The home theater
switches automatically to the audio
source of the connected device.
• [Audio Input Mapping] : Updates audio
input mapping if there are new devices
connected.
5
Press OK to confirm your choice.
• [Picture Settings]: Selects a predefined
color setting.
5
Press OK to confirm your choice.
Note
• The best setting is automatically selected for
the TV. If you change the setting, ensure that
the TV supports the new setting.
• For settings related to HDMI, the TV must be
connected through HDMI.
• For settings related to progressive or
component video, the TV must be connected
through Component Video.
Change audio settings
1
Press (Home).
2
Select [Setup], then press OK.
3
Select [Audio], then press OK.
4
Select and adjust the following settings:
• [Night Mode] : Selects quiet or full
dynamic sound. Night mode decreases
the volume of loud sounds and
increases the volume of soft sounds
such as speech.
• [HDMI Audio] : Selects HDMI audio
format or disables HDMI audio output
for the TV.
• [Speaker Setup] : Sets the volume level
and distance of each speaker to obtain
the best possible surround sound
based on your room setup.
5
Press OK to confirm your choice.
Note
• For settings related to HDMI, the TV must be
connected through HDMI.
• Night mode is available for Dolby encoded
DVD and Blu-ray discs (for models support
Blu-ray playback).
English
EN