beautypg.com

Circuit priming – Philips 10003083 User Manual

Page 28

background image

• 28 •

• 28 •

Blinking

• Switch the power button to “I” to turn

the machine on.

Circuit Priming

• To prime the water circuit, place a

container under the steam wand
(Pannarello, if supplied).

• Make sure the selector switch is in the

“ ” position; if this is not the case, set
it to that position.

• To turn the machine on simply press the

“STAND-BY” button.

• The blinking icons shown in the picture

warn that the circuit must be primed.

Note: Before starting the
machine for the first time,

and after long periods of inactivity,
prime the water circuit.

• The “STAND-BY” button blinks.

Blinking

Slow blinking

Cyclic blinking

Steady on

• Turn the selector switch clockwise to set

it to the “

” position. The machine

starts the automatic priming of the
circuit by letting out a preset quantity
of water through the Pannarello.

Once the circuit has been primed, the

icons shown in the fi gure will start to
blink.

Turn the selection knob back to its

central position “ ”.

• The icons displayed blink slowly to

show that the machine is warming
up.

When warm-up is complete,
the machine performs a rinse

cycle of the internal circuits.
During this phase, the icons displayed
will blink in sequence.

• When the operations described above

are completed, the icons on the display
will illuminate.

The display will appear as
shown to the side. The di-

splayed aroma is the factory setting
when the machine is switch on for
the fi rst time, or it is the same as the
aroma that was selected for the last
brewed coff ee.

The machine is then ready to brew

beverages.

• To brew coffee, dispense hot water or

steam, and properly use the machine, ca-
refully follow the instructions provided.