Getting started – Philips 190B1CB-00 User Manual
Page 66
Getting Started
Your LCD Monitor
:
• Front View Product Description
• Setting Up and Connecting Your
Getting Started
Getting Started
Use the information file ( .inf) for Windows® 2000/XP/Vista or later
The built-in VESA DDC2B feature in Philips Monitors supports Plug & Play requirements for Windows® 2000/XP/
Vista. This information file ( .inf) should be installed in order that your Philips monitor can be enabled from the
'Monitor' dialog box in Windows® 2000/XP/Vista and the Plug & Play application can be activated. The installation
procedure based on Windows® 2000 , XP and Vista is specified as follows.
For Windows® 2000
1.
Start Windows® 2000
2.
Click on the 'Start' button, point to 'Settings', and then click on 'Control Panel'.
3.
Double click on the 'Display' Icon.
4.
Select the 'Settings' tab then click on 'Advanced...'.
5.
Select 'Monitor'
- If the 'Properties' button is inactive, it means your monitor is properly configured. Please stop installation.
- If the 'Properties' button is active. Click on 'Properties' button. Please follow the steps given below.
6.
Click on 'Driver' and then click on 'Update Driver...' then click on the 'Next' button.
7.
Select 'Display a list of the known drivers for this device so that I can choose a specific driver', then click on
'Next' and then click on 'Have disk...'.
8.
Click on the 'Browse...' button then select the appropriate drive F: ( CD-ROM Drive).
9.
Click on the 'Open' button, then click on the 'OK' button.
10.
Select your monitor model and click on the 'Next' button.
11.
Click on the 'Finish' button then the 'Close' button.
If you can see the 'Digital Signature Not Found' window, click on the 'Yes' button.
For Windows® XP
1.
Start Windows® XP
2.
Click on the 'Start' button and then click on 'Control Panel'.
3.
Select and click on the category 'Printers and Other Hardware'
4.
Click on the 'Display' Item.
5.
Select the 'Settings' tab then click on the 'Advanced' button.
6.
Select 'Monitor' tab
- If the 'Properties' button is inactive, it means your monitor is properly configured. Please stop installation.
- If the 'Properties' button is active, click on 'Properties' button.
Please follow the steps below.
7.
Click on the 'Driver' tab and then click on 'Update Driver...' button.
8.
Select the 'Install from a list or specific location [advanced]' radio button and then click on the 'Next' button.
file:///F|/manual spec/813/spec/cd/Q70G19C1813 1A 190B1/CD/Q70G19C1813 1A 190B1/lcd/manual/ENGLISH/190B1/install/gt_start.htm（第 1／2 页）2009-10-8 14:20:18