Philips TS2757C - Manual (Page 9)

POWER
SLEEP
A/CH STATUS/EXIT CC CLOCK
RECORD TV
VCR
ACC
SMART SMART SMART
SOUND PICTURE
MENU SURF
VOL CH
MUTE
1 2 3
4 5 6
7 8 9
0
TV/VCR
TIMER ACTIVE ON
CHANNEL 12
START TIME - - : - - AM
TIMER ACTIVE ON
CHANNEL 12
START TIME 08:30 AM
12 8:30
2
3
4
1
CHANGING
TO CHANNEL 6
IN 30 SECONDS
U sed along with the Clock fea-
ture, you can select a specific
time the television will turn on
when the Timer Active control is
turned ON.
Press the CLOCK button to
display the Clock onscreen menu.
Press the CURSOR UP ᮣ or
CURSOR DOWN ■ button until
the words START TIME are high-
lighted.
Enter the time to turn on the
TV using the NUMBERED but-
tons. If the first number is a single
digit first enter a zero then the digit
(ie, press “0”, then press “8”).
Press the CURSOR RIGHT
ᮣᮣ or CURSOR LEFT ᮤᮤ but-
tons to set either AM or PM time.
S
ETTING THE
TV’
S
S
TART
U
P
T
IME
BEGIN
S MART H ELP
Remember: Be sure to set
the Timer Active to ON.
POWER
SLEEP
A/CH STATUS/EXIT CC CLOCK
RECORD TV
VCR
ACC
SMART SMART SMART
SOUND PICTURE
MENU SURF
VOL CH
MUTE
1 2 3
4 5 6
7 8 9
0
TV/VCR
SET CLOCK 10:00 AM
TIMER ACTIVE ON
CHANNEL 12
START TIME - - : - - AM
3
1
2
U sed along with the Clock fea-
tures, you can select a specific
channel that the television will tune
to when the Timer Active control is
turned ON.
Press the CLOCK button to
display the Clock onscreen menu.
Press the CURSOR UP ᮣ or
CURSOR DOWN ■ button until
the word CHANNEL is highlighted.
Press the number buttons to
enter the start up channel you
would like the television to start on.
A
CTIVATING THE
S
TART
U
P
C
HANNEL
BEGIN
S MART H ELP
Remember: Be sure to set
the Timer Active control to
ON.
The onscreen menu will time out
and disappear from the screen when
you finish, or you can press the
STATUS/EXIT button to clear the
menu from the screen.
If the TV is in use when the
START TIME control is about
to be activated, the screen will
display a warning stating it's
going to change channels in 30
seconds. It will appear like the
screen shown below and
change to the selected start up
channel. Pressing any button
on the remote within this count
down will cancel the change.