Philips 40PFL4907-F7 - Manual (Page 14)

English
14
9
Press OK to finish Settings assistant.
Store your preferences.
Cancel Store
• Network updates will appear after Connection test succeeds.
Use ◄► to select Yes, then press OK.
• When the initial setup is completed, the lowest memorized
channel with the confirmation message of the location setting
will be displayed on the TV screen.
Note
• If you are not receiving a signal from your cable service, contact the Cable provider.
• If you press during AutoProgram, this setup of TV channels will be canceled.
• The initial AutoProgram function can be executed for either Antenna or Cable only
once. When you change the connection (Antenna / Cable), set Autoprogram again.
➠ p. 37
After an initial setup is completed...
• If you want to scan the channels automatically again.
Autoprogram ➠ p. 37
• You can add the desired cable and Analog channels
unmemorized by AutoProgram.
Weak channel installation ➠ p. 37
• If you want to change to another language.
Language ➠ p. 36
• If you want to change the country setting.
Country ➠ p. 19
• If you want to change the location setting.
Location ➠ p. 38
• If you want to change the network setting.
Network ➠ p. 40
• If you want to restore the picture setting.
Settings assistant ➠ p. 30