Siemens WTXD5321US - Manual (Page 9)

9
Dryer rack
part no. WZ20390
Use the dryer rack to dry washable
woolen textiles (e.g. sweaters) and
shoes.
Left hinge kit
part no. WZ20360
The door catch can be reversed if
necessary. The door is hinged on the
right at the factory.
Pedestal Mounting
If mounting the dryer on the Siemens
pedestal (accessory no.
WZ 20395) follow the instructions
supplied with the pedestal.
Installation ć step by step
1. Unpack the dryer.
2. Remove all objects from the drum.
3. Check the dryer for visible
damage.
4. Position the dryer near the
installation location.
5. If required, change the door hinges
to the left (see page 6).
6. If required, have customer service
install the exhaust air outlet on the
dryer (see page 7).
7. Have the power supply cord fitted
by an authorized technician (see
page 6).
8. Install exhaust duct if necessary.
Follow the installation instructions
supplied by the appropriate
manufacturer!
i If space is very restricted, it is
recommended to fit the initial parts
of the exhaust duct to the dryer
before the dryer is moved to its
final installation location.
9. Move the dryer to its final location
and align.
CAUTION
Do not slide dryer across the floor if
heightĆadjustable feet have been
extended. Feet and/or dryer base
may be damaged if dryer is slid
across floor with heightĆadjustable
feet extended.
10. Position and then level the dryer .
The dryer should be level with all
four feet firmly on the ground. The
dryer must not wobble. If the dryer
is not level or if it does wobble, the
feet must be adjusted. Adjust the
heightĆadjustable feet until the
dryer does not rock and is level,
both frontĆtoĆback and
sideĆtoĆside.
11. Connect the exhaust duct to the
exhaust air outlet on the dryer.
12. Insert plug into the wall receptacle.
Check list before using
the dryer
1. Check that steps 1-12 have been
implemented properly.
2. Ensure that the dryer is connected
to the power supply.
3. Read the operating instructions to
understand how your dryer
operates.
4. Conduct an appliance test:
q Check that the drum is empty.
q Close the dryer door.
q Switch the dryer to "extra dry"
and then press the Start
button.
q After 3-5 minutes press the
Stop button and open the door.
5. If the interior of the dryer feels
warm, the dryer has been
connected properly.
Switch the dryer to "off".
6. If the dryer does not work, switch
the dryer to "off".
Look in the troubleshooting
section (page 40) of the
OPERATING INSTRUCTIONS and
find the fault.
Preparing to transport the
dryer ć step by step
1. Rotate the program selector
to "off".
2. Pull out the power supply plug.
3. Disconnect the exhaust duct from
the exhaust air outlet on the dryer.
4. Place any accessories in the drum.
5. Close the door and secure with
adhesive tape.
6. Screw the heightĆadjustable feet of
the dryer into the housing to
prevent them from being damaged
during transportation.