Philips VRX462AT99 - Manual (Page 53)

Go-To Feature 53
4
Within 10 seconds, press the PLAY, STOP, POWER, or
REC(ord)/OTR button. The VCR will fast forward or rewind
the tape to the selected tape counter location. The tape counter
will appear on-screen as the VCR rewinds or fast forwards the
tape. Then, depending on which button you pressed, the VCR will
either begin tape playback, stop the tape, turn itself off, or start
recording the current channel.
Button pressed VCR action
PLAY Begin tape playback
STOP Stop the tape
POWER Turn off VCR
REC(ord)/OTR Begin recording current channel
NOW 1: 00 : 00
GOTO –: – – : – –
NOW 1: 00 : 00
GOTO 1: 20 : 00
Follow the steps below to program the VCR to go to a place on a
tape with a specified tape counter location number.
• Make sure the VCR is in VCR position. (The VCR light will
appear on the display panel. If it does not, press the VCR/TV
button once.)
1
Press the VCR button.
2
When tape playback is stopped, press the GO-TO button
to bring up the GOTO display.
3
Within 10 seconds, use the Number buttons to enter the
desired tape counter location number. For example, to go
to tape counter location number 1:20:00, press Number buttons
1, 20, 00.
NOTE: If the desired tape counter location number has a minus (–)
before it, enter the minus by pressing the CHANNEL Down button.
Press the CHANNEL Up button to remove the minus.
...
...
POWER
CBL/DSS VCR TV
EJECT MUTE
MENU EXIT/STATUS CLEAR
VCR PLUS+
/ENTER LIGHT
F.ADV
PAUSE/STILL
1 2 3
4 5 6
7 8 9
100 0 GO-TO
MEMORY INDEX
VAR. SLOW
REMOTE LOCATOR
SKIP
VCR/TV SPEED SEARCH SLOW
TRACKING
STOP
REW FF
PLAY
VOL CHANNEL
/OTR REC
2
3
4
1
• To remove the GOTO display, press
the GO-TO button again.
• The tape counter location number
you enter at step 3 must be valid.
• To stop the tape during rewinding
or fast forwarding (before the tape
reaches the requested tape counter
location number), press the STOP
button.
Helpful Hints