Philips VRX462AT99 - Manual (Page 11)

Turning on Your VCR (cont’d) 11
7
Press the CHANNEL Up button to begin automatic channel
programming. AUTO SET PROCEEDING/PLEASE WAIT will
appear on-screen. The VCR will place all of the channels you
receive into its memory, so when you scan through channels using
the CHANNEL Up/Down buttons, you’ll only scan through chan-
nels that you receive.
CONNECT ANTENNA OR CABLE
TO VCR
THEN…
PUSH CH UP KEY
OR…
FOR PLAY ONLY – PUSH STOP
6
Press the MENU button. The menu shown below will appear.
8
When channels are programmed, AUTO SET COMPLETED will
appear on-screen briefly.
Then, the following menu will appear, giving you the option to set
up the VCR Plus+ Programming System now, if you prefer.
9
If you do not want to set up the VCR Plus+ Programming
System now, press the EXIT/STATUS button. You may set
up the VCR Plus+ Programming System later by following the
instructions on pages 38 - 39.
If you do want to set up the VCR Plus+ Programming
System now, press the MENU button. Follow the instruc-
tions from step 6 on page 39 to complete this task.
VCR PLUS+ USER
TO SET UP VCR PLUS+
CROSS REFERENCE CHANNEL
MAP, REFER TO
INSTRUCTION BOOK.
PUSH MENU TO SET REF MAP
OR...
TO END PUSH EXIT
...
...
POWER
CBL/DSS VCR TV
EJECT MUTE
MENU EXIT/STATUS CLEAR
VCR PLUS+
/ENTER LIGHT
F.ADV
PAUSE/STILL
1 2 3
4 5 6
7 8 9
100 0 GO-TO
MEMORY INDEX
VAR. SLOW
REMOTE LOCATOR
SKIP
VCR/TV SPEED SEARCH SLOW
TRACKING
STOP
REW FF
PLAY
VOL CHANNEL
/OTR REC
9
8
6
7
Wait for the VCR to program
channels.
• You may not be able to program
channels at step 7 if you are using
a Cable Box or DSS Receiver.
Helpful Hint