Philips VR620CAT99 - Manual (Page 47)

47 Glossary / Specifications
Glossary
AUDIO IN/OUT Jacks: jacks on the front and back of the
VCR that record audio from another source (IN) or send audio
to another system (OUT).
Automatic Channel Setup: process in which the VCR mem-
orizes all available channels. Then, when you press the
CH(annel) o/p buttons, you only scan through channels you
receive.
Bands: settings that allow you to tune channels.
• Antenna – VHF (very high frequency; channels 2-13) and
UHF (ultra high frequency; channels 14-69).
• Cable – all standard channels can be received without a
Cable Box.
Cable Box/DBS Output Channel: 03 or 04.
Dubbing: copying a tape using a second VCR.
Frame: a still picture.
HQ: high quality; a feature in the VCR circuitry which provides
enhanced picture detail.
Line Input: The channel to which you set your VCR during dub-
bing. If you use the AUDIO and VIDEO In jacks on the front of
the VCR, select channel 002 (AV FRONT). If you use the AUDIO
and VIDEO IN jacks on the back of the VCR, select 001 (AV
REAR). If you accidentally enter Line Input mode, press the
CH(annel) o/p buttons or use the Number buttons to select
another channel.
OTR: One-Touch Recording; a timed recording that starts
immediately and records for 30 minutes to eight hours.
Remote Control: the small electronic unit that came with
your VCR; allows you to operate your VCR from a distance.
RF coaxial cable: The black cable supplied with your VCR.
Use it to connect your VCR to your TV (or Cable Box or
DBS). The supplied cable is a snap-on type. However, you may
use a screw-on type if you prefer.
Special Effects: forward and reverse searching; a still picture;
slow motion playback.
Tape Speeds: how fast the tape travels during a recording or
playback.
• SP (standard play) – fastest tape speed (recording time for a
T120 tape is approximately two hours); best picture quality.
• LP (long play) – average tape speed; playback only.
• SLP (super long play) – slowest tape speed (recording time
for a T120 tape is approximately six hours).
VCR: video cassette recorder.
VIDEO IN/OUT Jacks: jacks on the front and back of the
VCR that record video from another source (IN) or send video
to another system (OUT).
Specifications
Video Heads
Four heads - Hi-Fi
Video Signal
EIA standards; NTSC color
Antenna
VHF/UHF – 75 ohm external antenna
terminal
VHF Output Signal
Channel 03 or 04 (switchable)
75 ohms unbalanced
Power Requirement
120V AC; 60Hz
Power Consumption
14W
Operating Temperature
41°F (5°C) to 104°F (40°C)
Relative Humidity
10% to 80%
Weight
5.3 lbs. (2.4 kg.)
Dimensions
14-3/16” (W) x 3-5/8” (H) x 8-1/2” (D)
(360mm x 92mm x 215.5mm)
Tuner Broadcast Channels
VHF 2-13, UHF 14-69
Cable TV Channels
1-125
NOTE: Designs and specifications are sub-
ject to change without notice.