Assembly, Mast assembly (mast not included) – Philips SDV9011K-17 User Manual

Page 7

E N

Assembly

• Attach one 46˝ Element to hole A in VHF Boom-B.

• Attach one 50˝ Element to VHF Boom-B.

Repeat each steps with second boom for VHF Boom-B.

• Insert VHF Boom-B into VHF Boom-A and secure

using 1-1/2˝ screw and lock washers. Repeat steps

for 2nd boom as well.

• Attach tubing brace to rear of VHF Boom with 1-

1/2˝ screws and wing-nuts.

• Slide UHF Boom through center slot of VHF Boom

support block until hole A of UHF Boom aligns with

hole B of VHF Boom. Secure with 1-1/2˝ screw

and wing-nut.

• Attach phasing wire and lead-in wire to UHF antenna

using 3/4˝ screws, washers, and wing-nuts.

• Insert end caps at ends of all booms.

Mast Assembly (Mast not included)

• Assemble U-bolts to cross pieces.

• Use saddle on center of boom.