Philips PORTABLE RADIO CASS REC + CD - Manual (Page 9)

English
POWER SUPPLY
9
Whenever convenient, use the power supply if you want to
conserve battery life. Make sure you remove the plug from the
set and wall outlet before inserting batteries.
BATTERIES (OPTIONAL)
1. Open the battery compartment and insert six batteries, type
R-14, UM-2 or C-cells, (preferably alkaline) with the correct
polarity as indicated by the "+" and "-" symbols inside the
compartment.
Remote control (supplied)
Open the battery compartment and insert two batteries,
type AAA, R03 or UM4 (preferably alkaline).
2. Replace the compartment door, making sure the batteries are
firmly and correctly in place. The set is now ready to operate.
– Incorrect use of batteries can cause electrolyte leakage and
will corrode the compartment or cause the batteries to burst.
Therefore:
– Do not mix battery types, e.g. alkaline with carbon zinc.
Only use batteries of the same type for the set.
– When inserting new batteries, do not try to mix old
batteries with the new ones.
– Remove the batteries if the set is not to be used for a long
time.
Note: The battery supply is switched off when the set is
connected to the mains.
Batteries contain chemical substances, so they should be
disposed of properly.
Using AC POWER
1. Check if the power voltage as shown on the type plate
located on the base of the set, corresponds to your local
power supply. If it does not, consult your dealer or service
center.
2. Connect the power cord to the MAINS outlet and the wall
outlet. The power supply is now connected and ready for use.
3. To switch off completely, withdraw the power cord from the
wall outlet.
– Disconnect the power cord from the wall outlet to protect your
set during heavy thunderstorms.
The type plate is located on the bottom of the set.
6 x R14•UM-2•C-CELL
MAINS
AZ 1120 /17
page
9
2 x AAA/R03/UM