Philips PORTABLE RADIO CASS REC + CD - Manual (Page 15)

RECORDING
15
GENERAL INFORMATION ON RECORDING
• Recording is permissible insofar as copyright or other rights of
third parties are not infringed.
• This deck is not suitable for recording on CHROME (IEC II) or
METAL (IEC IV) type cassettes. For recording, use only
NORMAL type cassettes (IEC I) on which the tabs have not
been broken.
• The best recording level is set automatically. Altering the
VOLUME and DBB controls will not affect the recording in
progress.
• At the very beginning and end of the tape, no recording will
take place during the 7 seconds, when the leader tape passes
the recorder heads.
• To protect a tape from accidental erasure, have the tape in
front of you and break out the left tab.
Recording on this side is no longer possible. To record over this
side again, cover the tabs with a piece of adhesive tape.
SYNCHRO START CD RECORDING
1. Select CD source.
2. Insert a CD and if desired, program track numbers.
3. Press STOP•OPEN
9/ to open the cassette door.
4. Insert a suitable cassette into the cassette deck and close the
cassette door.
5. Press RECORD
0 to start recording.
– Playing of the CD program starts automatically from the
beginning of the program. It is not necessary to start the CD
player separately.
To select and record a particular passage
• Press and hold down on SEARCH
∞ or §.
• When you recognize the passage you want, release SEARCH
∞ or §.
• To pause CD playback press PLAY/PAUSE
2;.
– Recording will begin from this exact point in the track when
you press RECORD
0.
6. For brief interruptions during recording, press PAUSE
;. To
resume recording, press PAUSE
; again.
7. To stop recording, press STOP•OPEN
9/.
AZ 1040 /17
page
15
English
AZ 1040 /17
page
15
AZ 1040 CD RAD IO CASS ETTE RE CORDER
RECORD
PLAY
SEARCH
STOP-OP EN
PAUSE
DBB
POWER
TUNER
DYNAM IC BASS BOOST
CD TAPE OFF
+
PROG
BATT
LOW
MODE
STOP
PLAY•PA USE
SEARCH
PR
DIGITAL
TUNER
1
XP AZ 1040/17 02-02-2000 11:50 Pagina 15