Philips PORTABLE RADIO CASS REC + CD - Manual (Page 11)

English
DIGITAL TUNER
11
TUNING TO RADIO STATIONS
1. Select TUNER source.
™
is displayed briefly and then the radio station
frequency is shown.
2. Press BAND once or more to select your waveband.
3. Press SEARCH
∞ or § and release when the frequency in
the display changes.
™ The radio automatically tunes to a station of sufficient
reception. Display shows during automatic tuning.
™ If a FM station is received in stereo,
STEREO is shown.
4. Repeat step 3 if necessary until you find the desired station.
• To tune to a weak station, press SEARCH
∞ or § briefly and
repeatedly until you have found optimal reception.
5. Adjust the power slider to TAPE/OFF position to switch off the
set.
To improve radio reception
– For FM, pull out the telescopic antenna. Incline and turn the
antenna. Reduce its length if the signal is too strong (very
close to a transmitter).
– For AM, the set is provided with a built-in antenna so the
telescopic antenna is not needed. Direct the antenna by
turning the whole set.
Programming radio stations
You can store up to a total of 30 radio stations in the memory.
1. Tune to your desired station (see Tuning to radio stations).
2. Press PROG to activate programming.
– Display:
PROGRAM
flashes.
3. Press PRESET
4 or 3 once or more to allocate a number from
1 to 30 to this station.
4. Press PROG again to confirm the setting.
– Display:
PROGRAM disappears, the preset number and the
frequency of the preset station are shown.
5. Repeat the above four steps to store other stations.
– You can overwrite a preset station by storing another
frequency in its place.
Tuning to preset stations
Press PRESET
4 or 3 until the desired preset station is displayed.
AZ 1040 /17
page
11
PROG
BATT
LOW
MODE
STOP
PLAY•PA
USE
SEARCH
L TUNER
FM STEREO
PROG
BATT LOW
STOP
LAY•PA USE
SEARCH
SHUFFLE
ALL
BAND PRESET
DIGITAL
TUNER
PROG
BATT LOW
OP
RECORD
AY
SHUFFLE
ALL
BAND PRESET
DIGITAL
TUNER
XP AZ 1040/17 02-02-2000 11:50 Pagina 11